Прочитайте текст и выполните задания
Flicker
1. The first requirement to be met in image analysis is that the reproduced picture shall not flicker, since flicker induces severe visual fatigue. Flicker becomes more evident as the brightness of the picture increases. If flicker is to be unobjectionable at brightness suitable for home viewing during daylight as well as evening hours, the successive illuminations of the picture screen should occur no fewer than 50 times per second. This is approximately twice the rate of picture repetition needed for smooth reproduction of motion. To avoid flicker, therefore, twice as much channel space is needed as would suffice to depict motion.
2. The same disparity occurs in motion picture practice, in which satisfactory performance with respect to flicker requires twice as much film as is necessary for smooth simulation of motion. A way around this difficulty has been found, in motion pictures as well as in television, by projecting each picture twice. In motion pictures, the projector interposes a shutter briefly between film and lens while a single frame of the film is being projected.
3. In television, each image is analyzed and synthesized in two sets of spaced lines, one of which fits successively within the spaces of the other. Thus the picture area is illuminated twice during each complete picture transmission, although each line in the image is present only once during that time. This technique is feasible because the eye is comparatively insensitive to flicker when the variation of light is confined to a small part of the field of view.
4. It is thus possible to avoid flicker and simulate rapid motion by a picture rate of about 25 per second, with two screen illuminations per picture. The precise value of the picture-repetition rate used in a given region has been chosen by reference to the electric power frequency that predominates in the region.
(Encyclopedia Britannica)
Определите, какое утверждение не соответствует содержанию текста.
Projecting each picture twice promotes smooth picture reproduction.
At a picture rate of 50 times per second twice as much channel space is needed to avoid flicker.
Flicker depends on the brightness level.
Illumination doesn’t influence rapid motion reproduction at a picture rate of about 25 per second.